How to install your reflective curb numbers

Watch the how-to video

Watch the whole video once before you start.

Step-by-step instructions

Take your time with steps 1 and 3. A clean curb and good adhesive coverage make your tiles last.

1. 1

   Clean the curb

   Scrub the spot with the wire brush to remove dirt, dust and loose concrete. Wipe it off so the surface is clean and dry.

   Tip: The adhesive needs clean & dry concrete to bond. Don't skip this step.
2. 2

   Unpack your tiles

   Take everything out of the box. Your tiles come already assembled.

   Important: Leave the protective tape on your tiles for now. You'll remove it after 48 hours. It keeps adhesive off the front of the tiles for a clean finish.
3. 3

   Apply the adhesive

   Apply a generous amount of adhesive to the back of each tile. Cover the edges and the middle.

   Wait about 90 seconds until the adhesive feels tacky.

   Tip: The tackier your adhesive is, the better!
4. 4

   Place and roll the tiles

   Set the tiles where you want them and press them down firmly.

   Use the included roller to roll up and down and side to side, pushing out any air bubbles.

   Tip: A little bit of adhesive is going to come out on each side of the tile, this is ok! Wipe it off with your gloved hand and discard safely. You want these tiles suctioned to the curb.
5. 5

   Let it set for 48 hours

   Leave the tiles alone for about 48 hours. Don't drive, park or step on them during this time.

   Tip: Set out a cone or trash can to remind everyone to stay off the curb.
6. 6

   Remove the tape after 48 hours

   After 48 hours, slowly peel the clear tape off the front of the tiles. Wipe away any extra adhesive around the edges.

   That's it. Your address is now easy to see day or night.

   Tip: Peel the tape at a low angle, pulling it back over itself.